Specifications

43" / 43.5"  x 200"  IMOR  "EXTRA HEAVY DUTY" ROLL LATHE


New:1970
Serial No.:50 - N - 3863
Model:EHD1100
Series:"Extra Heavy Duty"


EQUIPPED WITH:
Heid 360 Degree 2 - Axis Tracer Attachment
Extra heavy bed
32"  4 - jaw chuck
Steady rest
Flame hardened bed ways
Heavy duty Timken Bearings
Power rapid traverse to carriage
Power rapid traverse to tailstock

CATALOGUE SPECIFICATIONS:
Hole thru spindle:4"
Swing over bed ways, rated:43"
Swing over bed ways, actual:43.5"
Swing over carriage (left side):39.5"
Swing over cross slide:34"
Distance between centers:200"
Cross-slide cross-feed travel:23"
Top-slide cross feed travel:10"
Tailstock, spindle diameter:7.5"
Tailstock, spindle travel:10"
(24) Spindle speeds, range2  to  190 RPM
(70) Carriage longitudinal feeds:.0019  to .2240  IPR
(70) Cross-slide cross feeds:.0012  to .1408  IPR
Main motor, horsepower/RPM:125  HP /  1800 RPM
Rapid traverse motor, horsepower5  HP
Tailstock rapid traverse motor:2  HP

CONDITION:
Appears to be in very good condition.

NOTE:
Bearing capacity at 50 RPM - Front spindle bearing radial load of 99,750 lbs, Thrust
load of 56,460 lbs., Center spindle bearing radial load of 72,950 lbs, Thrust load of
41,650 lbs.  Rear ball bearing radial load of 25,630 lbs.

 

367 Mansfield Avenue, Pittsburgh, PA 15220 USA
Tel: (412) 928-2880 | Fax: (412) 928-2881

©1999 Sherman International Corporation. All rights reserved.

Please contact our Webmaster with questions or comments.